Reboot The Wireless Access Point Without Restoring The Default Configuration - NETGEAR ProSAFE WN203 Reference Manual

ProSAFE Single Band 802.11n Wireless Access Point WN203
During the restoration process, the wireless access point automatically restarts. The
restoration process typically takes about one minute. When the Test LED turns off, wait a
few more seconds before doing anything with the wireless access point.
Use the Reset to Factory Defaults Button to Restore Factory Default
Settings
To restore the factory default settings when you do not know the login user name, login
password, or IP address, you need to use the Reset to Factory Defaults button on the bottom
panel of the wireless access point (see

To restore the factory default settings using the Reset to Factory Defaults button:
1. Using a sharp object, press and hold the Reset to Factory Defaults button for about
10 seconds to reset the wireless access point to factory default settings.
Note: Pressing the Reset to Factory Defaults button for a few seconds
simply causes the wireless access point to reboot.
2. Release the Reset to Factory Defaults button.
During the restoration process, the wireless access point automatically restarts. The
restoration process typically takes about one minute. When the Test LED turns off, wait a
few more seconds before doing anything with the wireless access point.
Reboot the Wireless Access Point without Restoring the
Default Configuration
If you do not have physical access to the wireless access point to switch it off and on again,
you can use the software to reboot the wireless access point.

To reboot the wireless access point:
1. Select Maintenance > Reset > Reboot AP.
The Reboot AP screen displays:
Figure 3 on page 13).
Management
60