Table of Contents
Advertisement
REPEAT
SEARCHING
SPEAKER
UNKNOWN CALLER/ The incoming call is from an area not serviced by Caller ID or
NAME/NUMBER
Handset Sound Signals
Signal
A long warbling tone (with ringer on)
Three short beeps
One long beep
One short beep (during room monitoring mode)
One short beep (every 7 seconds)
Troubleshooting Guide
Telephone Solutions
No dial tone
• Check and repeat installation steps:
Ensure the base power cord is connected to a working electrical outlet .
Ensure the telephone line cord is connected to the base and the wall jack.
• Connect another phone to the same jack; if there is still no dial tone, the problem
might be your wiring or local service.
• The handset may be out of range of the base. Move closer to the base.
• Ensure the battery is properly charged (16 hours).
• Ensure the battery pack is installed correctly.
• The handset should beep when you press the TALK button and the charge
indicator should be lit when the handset rests in the cradle. If not, the battery
may need to be charged.
• Place handset in charge cradle for at least 0 seconds to reset the unit.
Repeat call message. Indicates that a new call from the same
number was received more than once.
Indicates handset is searching for the base.
Indicates the handset is in speakerphone mode.
the information was not sent.
.
Meaning
Signals an incoming call
Page signal
Confirmation tone for the
completion of a function
Ring alert tone
Low battery warning
47
Advertisement
Table of Contents
