GE 15432970 User Manual page 16

Problem
Cannot hear the
Page alert tone
Range is shorter
than normal
Battery will not hold a
charge or is fully charged
and the BAT LOW lights
BAT LOW light stays on
Memory Dialing
doesn't work
Unit locks up
No link between base
and handset.
16
Solution
• Set the RING/PWR switch on the handset to ON (the far left
position).
• Press the CHAN button during the conversation to select a
new channel.
• Position the base antenna upward.
• Be sure you are sufficiently charging the battery. When the
battery has been charged for 12 hours, you can expect
approximately 4 hours of talk time.
• Check to be sure battery contacts on both the handset and
the base are making contact and are clean; free of dirt or lint.
• When the handset is placed in the base, check that the base
CHARGE light is on.
• Place handset in base for 10 seconds to reset the phone. If
that doesn't work, charge battery for 12 hours.
• Did you program the memory location keys correctly?
• Did you follow proper dialing sequence?
• Make sure T/P switch is correctly set.
• If the unit doesn't work, turn the power switch on the handset
off. Hold down digit 2 and 8 simultaneously and then turn the
power switch on. Put the handset back on the base and press
the PAGE button until you hear a beep.
• If a power outage occurs while the handset is away from the
base, the handset must be returned to the base when the
power returns.
ID code between handset and base could be lost. Follow
these instructions: Make sure power switch on the handset is
OFF. Turn the power switch ON while holding down digit 2
and 8 simultaneously. Put the handset down on the base.
Press "PAGE" button until beep sound comes out. Beep
sound indicates that ID code is correctly restored.