Troubleshooting; Precautionary Notes - Health O Meter 7631 User Manual

Note:
1. The data in the memory will not be lost even when the Blood Pressure
Monitor is switched off.
2. You can erase the memories stored by removing the batteries.

Troubleshooting

If a problem should arise during use, please check the following points.
Symptom
No display when the POWER
button is pressed
EE mark shown on the display
or the blood pressure value
is displayed excessively low
(or high)
Note: If the unit still does not work, please see the Warranty Information
in this manual. Under no circumstance should you disassemble
the unit and attempt repairs yourself.

Precautionary Notes:

1. Your Health o meter
avoid extreme temperatures, humidity, and direct sunlight. Avoid dropping or
sharp impacts to the main unit, and protect it from dust.
2. Clean the blood pressure monitor body and the cuff carefully with a slightly dampened
soft cloth. Do not press on the unit too hard Do not wash the cuff or use chemical
cleaners on it. Never use thinner, alcohol or petrol (gasoline) as cleaner.
3. Leaky batteries can damage the unit. Remove the batteries when the unit
is not used for an extended period of time.
Check Point
Have the batteries run down?
Have the batteries been
properly positioned in the
compartment?
Is the cuff tensioned correctly?
Is the cuff placed correctly?
Did you talk or move during
the measurement?
Did you shake the arm with the
cuff on it?
®
monitor contains high-precision components. Therefore,
12 22
Correction
Replace them with 4 new
"AA" alkaline batteries
Re-insert the batteries
in the correct position
Wrap the cuff properly so
that it is positioned correctly
Measure it again quietly