Assembly - Weslo Cadence Sl30 User Manual

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver
1. With the help of a second person, carefully raise the
treadmill to the upright position.
While the other person tips the treadmill to one side and
holds it, insert an Extension Leg (59) into one side of
the Base (32). Make sure that the Extension Leg is
turned so the bracket is on the side shown. Using the
Allen Wrench (102), tighten an Extension Leg Screw
(57) into the Extension Leg and the Base. Attach the
other Extension Leg in the same manner.
2. Refer to HOW TO LOWER THE TREADMILL FOR
USE on page 11. Follow the instructions in step 2 to
lower the treadmill.
Without removing the tape from the Latch (34), hold the
Latch against the left Upright (32) as shown. Attach the
Latch to the left Upright with four of the six Screws (33).
Make sure that the Screws are tight, but do not
overtighten them; if the Screws are overtightened,
the Latch will not slide smoothly. After the Latch is
attached, remove any visible tape.
Note: The inset drawing shows how the parts of the
Latch (34) fit together.
3. Cut the plastic tie holding the cage nut in the upper end
of the Left Handrail (60).
Position the Left Handrail (60) against the left Upright
(32) as shown. The bracket on the Extension Leg (59)
should be inside of the lower end of the Left Handrail.
Thread a Handrail Bolt (30) with a Handrail Washer
(108) into the left Upright and the Left Handrail. Do not
tighten the Handrail Bolt yet.
, adjustable wrench
1
102
57
2
32
34
33
33
3
5
, and scissors.
Bracket
32
59
Spacer
Bracket
Plastic Tie
30
108
60
32
59
Springs
Latch