Assembly - Weslo Cadence R20 Treadmill User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included small allen wrench
rubber mallet
pliers .
To identify small parts during assembly, use the PART IDENTIFICATION CHART in the center of this manual.
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the
treadmill onto one side. Partially fold the Frame (75) so
that the treadmill is more stable. Do not fully fold the
treadmill until it is completely assembled.
Attach four Base Pads (40) to the Base (11) with four
3/4" Tek Screws (102).
2. With the help of a second person, tip the treadmill down
to the position shown.
Attach a Wheel (37) to each side of the Base (11) with a
Wheel Bolt (36) and a Wheel Nut (38) as shown.
Identify the Right Upright (62) and the Left Upright (76)
(there are two small holes in the side of the Left Upright).
While a second person holds the Right Upright near the
Wire Harness (21), insert the end of the Wire Harness
into the lower end of the Right Upright and out of the
upper end.
, wire cutters
and your own phillips screwdriver
, adjustable wrench
1
75
11
2
Holes
5
, and needlenose
40
102
40
102
76
11
37
38
36
,
40
102
62
21