Installing The Chassis Into The Rack - Bosch DIVAR DIP-6080-00N Quick Installation Manual

14 en | System setup - hardware
To install the outer rails to the rack:
1.
2.
3.
4.
Locking Tabs
Both chassis rails have a locking tab, which serves two functions. The first is to lock the
system into place when installed and pushed fully into the rack, which is its normal position.
Secondly, these tabs also lock the system in place when fully extended from the rack. This
prevents the system from coming completely out of the rack when you pull it out for servicing.
3.4.4

Installing the chassis into the rack

To install the chassis into a rack:
1.
2.
3.
4.
Warning!
!
Do not pick up the unit with the front handles. The handles are designed to pull the system
from a rack only.
Warning!
Stability hazard
!
Before sliding the unit out for servicing make sure that the rack stabilizing mechanism is in
place, or the rack is bolted to the floor. Failure to stabilize the rack can cause the rack to tip
over.
See also:
Rack precautions, page 10
2013.05 | V3 | DOC
Secure the back end of the outer rail to the rack, using the screws provided.
Press the button where the two outer rails are joined to retract the smaller outer rail.
Hang the hooks of the rails onto the rack holes and if desired, use screws to secure the
front of the outer rail onto the rack.
Repeat steps 1-3 for the remaining outer rail.
Extend the outer rails as illustrated above.
Align the inner rails of the chassis with the outer rails on the rack.
Slide the inner rails into the outer rails, keeping the pressure even on both sides. When
the chassis has been pushed completely into the rack, it should click into the locked
position.
Optional screws may be used to secure the to hold the front of the chassis to the rack.
Quick Installation Guide
DIVAR IP 6000 2U
Bosch Sicherheitssysteme GmbH