Sanyo VPC-SX500EX Service Manual page 19

3. Slide the slide switch to camera, and turn on the LCD.
7. IC521 Oscillation Frequency Adjustment
CL594
Measuring Point
Measuring Equipment Frequency counter
ADJ. Location
VR521
200
ADJ. Value
Adjustment method:
1. Adjust with VR521 to 200
8. IC511 Oscillation Frequency Adjustment
L5101 ST side
Measuring Point
Measuring Equipment Frequency counter
ADJ. Location VR511
ADJ. Value 200
Adjustment method:
1. Adjust with VR511 to 200
9. 5.0 V (L) Voltage Adjustment
CL595
Measuring Point
Measuring Equipment Digital voltmeter
ADJ. Location
VR522
5.00
ADJ. Value
Adjustment method:
1. Adjust with VR522 to 5.00
10. AWB and AGC Adjustment
Serial cable
Camera
Preparation:
POWER switch: ON
Adjusting method:
1. When setting the camera in place, set it to an angle so that
nothing appears in any part of the color viewer except the
white section. (Do not enter any light.)
2. Double-click on the DscCalV122.
1 kHz
1 kHz.
1 kHz
1 kHz.
0.05 V
0.05 V.
0 - 18 cm
All white pattern
Color viewer (5,100K)
3. Click the AWB, and click the Yes.
4. AWB and AGC adjustment value will appear on the screen.
5. Click the OK.
11. Lens Adjustment
Serial cable
Camera
Preparation:
POWER switch: ON
Adjustment condition:
More than A3 size siemens star chart
Fluorescent light illumination with no flicker
Illumination above the subject should be 400 lux
Adjustment method:
1. Set the siemens star chart 95 cm
comes center of the screen.
2. Double-click on the DscCalV122.
3. Click the Focus, and click the Yes.
4. Lens adjustment value will appear on the screen.
5. Click the OK.
12. CCD Defect Detect Adjustment
Adjustment method:
1. Double-click on the DscCalV122.
2. Click the "CCD Defect", and click the "Yes".
3. After adjustment, adjustment value will appear on the screen.
13. LCD Panel Adjustment
[CA3 board (Side B)]
Approx.
95 cm 3 cm
Siemens
star chart
10 %.
3 cm so that it be-
L5101 (ST)
CL594
VR511
VR522
CL595
VR521