Weslo Cadence 1000 Fm User Manual page 8

6. Attach the end of the ground wire to the small hole in the
side of the Right Handrail (40) with a Silver Ground
Screw (66).
7. Set the console assembly onto the Left and Right
Handrails (13, 40). Be careful not to pinch the Wire
Harness (65). Tighten two Pulse Bar Screws (37), with
two #10 Star Washers (108), through the brackets on the
Handrails and into the Pulse Bar (39). Do not tighten
the Pulse Bar Screws yet.
8. Insert the Wire Harness (65) through the indicated nylon tie
on the Console Base (67). Next, touch the Right Handrail
(40) to discharge any static. See drawing 8a. Insert the
connector on the end of the Wire Harness into the red
socket beneath the Console (69). The connector should
slide easily into the socket and snap into place. If the
connector does not slide easily and snap into place, turn it
and then insert it. IF THE CONNECTOR IS NOT IN-
SERTED PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.
Identify the 3/4" Screws (38). Attach the Console Base
(67) to the Right Handrail (40) and the Left Handrail (not
shown) with six 3/4" Screws (only three Screws are
shown). Start all six Screws before tightening them; do
not overtighten the Screws.
Tighten the Pulse Bar Screws (37).
6
40
7
Console Assembly
40
108
37
8
40
38
8
66
Ground Wire
13
65
108
39
37
65
67
Tie
37
8a
69
65