Power Convertible Top Operation - Chrysler 200 Convertible User Manual

POWER CONVERTIBLE TOP OPERATION

• Before lowering the top, verify the cargo shield is perfectly positioned in the trunk.
Positioning The Cargo Shield For Top Operation
• Pull the cargo shield toward you to begin unfolding the panels. Grasp the handle in the center
of the outermost (top) panel and raise the cargo shield. Then, align and seat the tabs at each
end of the cargo shield in the V slots in the trunk liner as shown in the illustration.
Raising
• Press and hold the switch in the top up position until the operation of raising the top and
latching is complete. "TOP DONE" will be displayed in the odometer or "CONVERTIBLE
TOP COMPLETE" in the Electronic Vehicle Information Center once the convertible top is
completely raised and latched.
• Continue to hold the switch in the up position to completely raise all four windows.
Emergency Bypass Mode (To Raise The Top Only)
• This procedure is only to be used to raise the top when the top cannot be returned to the UP
(raised) position by pressing the POWER TOP switch or is in a position in which the vehicle
cannot be driven. Please follow these emergency bypass instructions to return the top to the
UP (raised) position.
• Press the POWER TOP switch in the Top Up direction five times within two seconds and hold
the switch in the Top Up position for a minimum of two minutes.
• If damage starts to occur while in the Emergency Bypass Mode, immediately release the
POWER TOP switch and see your authorized dealer.
NOTE: This procedure may take more time to fully raise and close the power top. It is not
uncommon to see delays of up to 30 seconds before operation begins.
OPERATING YOUR VEHICLE
• The power top switch will operate when the
Lowering
• The power top switch is located on the
• The power top switch has two top down
ignition switch is turned to the ON/RUN or
ACC position and when in the power
accessory delay.
center console.
positions which affect window position when
lowering the top.
• Press and hold the switch halfway down to
the first detent position to lower the top
and maintain the current window positions.
• Press and hold the switch fully down to the
second detent position to lower the top
and completely lower all four windows.
21