Ford Escape Owner's Manual page 180

Reasons for messages being displayed
The radar Clean the fascia area in
surface is front of the radar or remove
dirty or
obstructed
The radar Drive normally in traffic for
surface is a few minutes to allow the
not dirty or radar to detect passing
obstructed vehicles so it can clear the
Heavy rain- No action required. The
fall/snow- system automatically
fall inter- resets to an unblocked
feres with state once the rainfall or
the radar snowfall rate decreases or
signals stops. Do not use BLIS or
Cross Traffic Alert in these
System Limitations
The BLIS and Cross Traffic Alert systems
do have their limitations; situations such
as severe weather conditions or debris
build-up on the sensor area may limit
vehicle detection.
The following are other situations that may
limit the BLIS:
• Certain maneuvering of vehicles
entering and exiting the blind zone.
• Vehicles passing through the blind zone
at very fast rates.
• When several vehicles forming a
convoy pass through the blind zone.
The following are other situations that may
limit the Cross Traffic Alert system:
• Adjacently parked vehicles or objects
obstructing the sensors.
• Approaching vehicles passing at
speeds greater than 15 mph (24 km/h).
Escape (TM2)
Driving Aids
the obstruction.
blocked state.
conditions.
• Driving in reverse faster than 3 mph (5
km/h).
• Backing out of an angled parking spot.
False Alerts
Note: If the vehicle has a factory equipped
tow bar, and it is towing a trailer, the sensors
will detect the trailer and turn the BLIS and
Cross Traffic Alert off to avoid false alerts.
For non-factory equipped tow bars you may
want to turn the BLIS off manually.
There may be certain instances when
either the BLIS or Cross Traffic Alert
systems illuminate the alert indicator with
no vehicle in the coverage zone; this is
known as a false alert. Some amount of
false alerts are normal; they are temporary
and self-correct.
System Errors
If either system senses a problem with the
left or right sensor, the BLIS telltale
illuminates and remains on and the
following will appear in the information
display:
• BLIS: X sensor fault Service req'd or
• Cross Traffic malfunction Service req'd
Switching the Systems Off and On
One or both systems can be switched off
temporarily by using the information
display control. See General Information
(page 85). When the BLIS is switched off,
you will not receive alerts and a telltale
illuminates in the information display. The
system switches back on whenever the
ignition is switched on.
One or both systems can also be switched
off permanently at your authorized dealer.
Once switched off, switching it back on
must also be done at your authorized
dealer.
176