BMW Z4 sDrive28i Owner's Manual page 24

Controls
Confirmation signals from the vehicle
Operating principle, refer to page 62.
1. Switch on the ignition, refer to page 45.
2. Lightly push button 1 in the turn indicator
lever up or down repeatedly until the symbol
appears in the display, accompanied by the
word "SET".
3. Press button 2.
4. Lightly push button 1 in the turn indicator
lever down repeatedly until the desired sym‐
bol appears in the display.
▷ Confirmation signal during unlocking
▷ Confirmation signal during locking
5. Press button 2.
6. Use button 1 to select one of the following:
▷ The hazard warning system flashes
during unlocking/locking.
▷ An acoustic signal sounds during
unlocking/locking.
▷ The hazard warning system
lights up and an acoustic signal sounds
during unlocking/locking.
24
Opening and closing
Online Edition for Part no. 01 40 2 609 184 - 09 11 500
▷ The function is deactivated.
7. Press button 2.
The setting is stored.
Retrieving the seat and mirror settings
The driver's seat and exterior mirror positions
used last are stored for the remote control cur‐
rently in use.
When the vehicle is being unlocked, these po‐
sitions are automatically retrieved if the setting
is activated.
Keep the footwell behind the driver's seat
clear
When this Personal Profile function is used, first
make sure that the footwell behind the driver's
seat is free of obstacles. Failure to do so could
result in damage to the objects if the seat were
to move rearward.◀
The adjustment procedure is interrupted:
▷ When a seat position switch is pressed.
▷ When a button of the seat and mirror mem‐
ory is pressed briefly.
Operating principle, refer to page 62.
1. Lightly push button 1 in the turn indicator
lever up or down repeatedly until the symbol
appears in the display, accompanied by the
word "SET".
2. Press button 2.