Advertisement
ASSEMBLY
Place all parts in a cleared area and remove the packing materials; do not dispose of the packing materials until
assembly is completed. Read each assembly step before you begin. During assembly, make sure that all parts
are oriented as shown in the drawings. A Phillips screwdriver (not included) and two spanners (not included)
are required for assembly.
1. Before beginning assembly, make sure that you
have read and understand the information
above.
Attach the Backrest (3) to the Frame (1) with four
M6 x 16mm Screws (5).
2. Attach the Leg (2) to the Frame (1) with an M10 x
57mm Bolt (12), an M10 Nylon Locknut (13), and the
Adjustment Pin (14). Do not overtighten the Nylon
Locknut; the Leg should pivot freely. Make sure
that the Adjustment Pin is rotated until the bent
end is over the Frame.
3. Insert a Pad Bar (4) into the upper hole in the Leg
(2). Slide the two Small Foam Pads (6) onto the
Pad Bar.
Insert the Adjustment Foot (8) into the Leg (2) with
the warning decal in the indicated position. Insert
the remaining Pad Bar (4) into the lower hole in the
Leg and the Adjustment Foot. Slide the two Large
Foam Pads (7) onto the Pad Bar.
1
2
14
13
2
3
6
2
7
8
4
3
1
5
5
12
1
6
4
Warning Decal
7
Advertisement
