Synchronizing With Other Devices; Initializing The Settings; Checking The Signal Flow - Roland Studio-Capture Amplifier Owner's Manual

Synchronizing with Other Devices

If you're using a coaxial cable to synchronize the STUDIO-CAPTURE with another device, click the
"Device" menu, then click [Device Settings] and make the appropriate settings for "SYNC" and
"INPUT SELECTOR (15/16) . "
For details, refer to "Connecting Two STUDIO-CAPTURE Units" (p . 46) or "Synchronizing with Another
Digital Device" (p . 52) .
MEMO
The setting can also be controlled from the STUDIO-CAPTURE itself (p . 43) .

Initializing the Settings

The STUDIO-CAPTURE allows you to initialize each setting independently .
MEMO
• Settings can also be initialized from the STUDIO-CAPTURE itself (p . 44) .
• To restore the factory settings, refer to "Restoring the Factory Settings (Factory Reset)" (p . 54) .
1.
From the "Device" menu, choose [Initialize] .
2.
From the items shown, choose the item that you want to initialize .
Displayed item
ALL
MIC PRE
MONITOR MIX
REVERB
PATCHBAY
A confirmation screen will appear .
3.
Click [OK] to initialize, or click [Cancel] to cancel without initializing .

Checking the Signal Flow

From the "Device" menu, choose [Show the signal flow] to view a block diagram .
Using the STUDIO-CAPTURE Control Panel
Content that will be initialized
Preamp, monitor mixer, reverb, and patch bay
Compressor settings and preamp settings
Monitor mixer A–D settings
Reverb settings
Patch bay settings
41