Table of Contents
Advertisement
About cycle options.
NOTE: Not all features are available on all dryer models.
(Appearance and
features may vary)
SIGNAL
Alerts you that the cycle is complete. The beeper will continue to sound every two
minutes for the next 6 minutes, until the clothes are removed. The clothes should
be removed when the beeper goes off so wrinkles won't set in.
On some models, press SIGNAL to turn the beeper on or off.
On some models, press SIGNAL to select low or high volume, or to turn the beeper off.
EXTEND TUMBLE
Minimizes wrinkles by adding approximately 20 minutes of no-heat tumbling after
clothes are dry. The beeper will sound every 90 seconds to remind you to remove
the clothes. The EST. TIME REMAINING display will show 00 .
ADD TIME (on some models)
This option can be used to extend drying time at the end of any cycle. 10 minutes is
added each time the pad is pressed.
ANTI-BACTERIAL (on some models)
This option can only be used with the COTTONS or MIXED LOADS cycles.
This option reduces certain types of bacteria by 99.9%, including: Staphylococcus
aureus, Pseudomonas aeruginosa, and Klebsiella pneumoniae*. The anti-bacterial process
occurs when high heat is used during a portion of the drying cycle.
NOTE: Do not use this cycle on delicate fabrics.
* The Anti-Bacterial Cycle is Certified by NSF International (formerly National Sanitation
Foundation) to NSF Protocol P9 Sanitization Performance of Residential Clothes Dryers.
NSF
®
DELAY 1-8 HOURS (on some models)
Use to delay the start of your dryer for 1 to 8 hours. First choose your dry cycle and
any options. Then press this pad for the number of hours you want to delay the cycle.
Press the START pad to start the countdown.
The countdown time will be shown in the Est. Time Remaining display.
NOTE: If the door is opened while the dryer is in DELAY , the dryer will beep once a
minute to remind you to restart the countdown. The countdown time will not restart
unless the door is closed and START has been pressed again.
DAMP SIGNAL (on some models)
This option causes the dryer to beep when clothes have reached a damp dryness.
Remove items that you wish to hang dry. The DAMP SIGNAL will only beep when the
dryer SIGNAL is turned on.
WARM UP (on some models)
This option provides 10 minutes of warming time to warm up clothes. Perfect for use
on a cold day, or to warm towels or robes.
NSF Protocol P9
Sanitization Performance of
Residential Clothes Dryers
GEAppliances.com
11
Advertisement
Table of Contents
