Table of Contents
Related Manuals for GE DPSB613ED
Summary of Contents for GE DPSB613ED
- Page 1 Safety Instructions Operating Instructions Troubleshooting Tips Consumer Support Write the model and serial numbers here: Model # ______________ Serial # ________________ Owner’s Manual DPSB613 DPSB619 175D1807P536 49-90268 11-05 JR...
-
Page 2: What To Do If You Smell Gas
LP fuels. Properly adjusted dryers will minimize incomplete combustion. Exposure to these substances can be minimized further by properly venting the dryer to the outdoors. Installation and service must be performed by a qualified installer, service agency or the gas supplier. -
Page 3: Proper Installation
PROPER INSTALLATION This dryer must be properly installed and located in accordance with the Installation Instructions before it is used. If you did not receive an Installation Instructions sheet, you can receive one by visiting ge.com, or by calling 800.GE.CARES (800.432.2737). - Page 4 Do not allow children to play on, with, or inside this or any other appliance. WHEN USING YOUR DRYER s Never reach into the dryer while the drum is moving. Before loading, unloading or adding clothes, wait until the drum has completely stopped.
- Page 5 See the Loading and Using the Dryer section. s If yours is a gas dryer, it is equipped with an automatic electric ignition and does not have a pilot light. DO NOT ATTEMPT TO LIGHT WITH A MATCH.
-
Page 6: Dryer Control Panel
You can locate your model number on the label on the front of the dryer, behind the door. NOTE: Any time you make a selection that is incompatible with the chosen dry cycle, the dryer will beep twice. Model DPSB613... -
Page 7: One Touch Selections
Sensor Dry Plus feature, which continuously monitors the amount of moisture in the load and stops the OUCH dryer when the clothes are dry. Throughout this manual, features and appearance may vary from your model. PRESS... AUTOMATICALLY SELECTS... - Page 8 About drying cycles. Throughout this manual, features and appearance may vary from your model. DRYEL ™ This feature is designed for use with the DRYEL See product package for directions. For questions or issues related to the use and performance of DRYEL call 1.800.214.8913, or visit the DRYEL Automatic DRYEL DEWRINKLE...
- Page 9 4. Close door. 5. Push START. About heat settings. HIGH For regular to heavy cottons. MEDIUM For synthetics, blends and items labeled permanent press. For delicates, synthetics and items labeled Tumble Dry Low. EXTRA LOW For lingerie and special-care fabrics. ge.com...
- Page 10 SENSING light will flash. This means the dryer is continuously monitoring the amount of moisture in the load. The lights will continue until the dryer senses a low level of moisture in the load. At that point, the dryer will calculate and display the approximate time remaining.
- Page 11 Foundation) to NSF Protocol P154 Sanitization Performance of Residential Clothes Dryers. DELAY 1–8 HOURS Use to delay the start of your dryer for 1 to 8 hours. First choose your dry cycle and any options. Then press this pad for the number of hours you want to delay the cycle.
-
Page 12: Timed Dry
About cycle status. These cycle status indicator lights display what part of the cycle the dryer is in and remind you to clean the lint filter. SensorDry Plus This light comes on when a O TIMED DRY This light comes on when AIR DRY, DEWRINKLE, DRYEL is selected. - Page 13 (on some models) The stainless steel used to make the dryer drum provides the highest reliability available in a GE dryer. If the dryer drum should be scratched or dented during normal use, the drum will not rust or corrode. These...
-
Page 14: About Reversing The Door
(where you removed the filler plugs). Apply firm pressure to get the screw started in new holes. Loosen top screw from each hinge on the dryer face halfway. With one hand holding the top of the door and the other hand holding the bottom, remove the door from the dryer by lifting it UP and OUT. -
Page 15: Loading And Using The Dryer
They may cause fabric softener stains. Bounce ® Fabric Conditioner Dryer Sheets have been approved for use in all GE Dryers when used in accordance with the manufacturer’s instructions. Care and Cleaning of the Dryer The Exterior: Wipe or dust any spills or washing compounds with a damp cloth. -
Page 16: Venting The Dryer
Venting the dryer. For the best drying performance, the dryer needs to be properly vented. The dryer will use more energy and run longer if it is not vented to the below specifications. Carefully follow the details on Exhausting in the Installation Instructions. -
Page 17: Operation
Before you call for service… Troubleshooting Tips Save time and money! Review the charts on the following pages, or visit ge.com. You may not need to call for service. OPERATION Possible Causes Control pads not Controls accidentally put in responding service mode Dryer doesn’t start... - Page 18 • Follow directions on fabric softener package. • Use your dryer to dry only clean items. Dirty items can stain clean items and the dryer. • Sometimes stains which cannot be seen when the clothes are wet appear after drying.
- Page 19 • Try a fabric softener. • Bounce ® Fabric Conditioner Dryer Sheets have been approved for use in all GE Dryers when used in accordance with the manufacturer’s instructions. • Try a fabric softener. • Adjust setting to LESS DRY or DAMP.
- Page 20 Notes.
- Page 21 You can rest easy, knowing that all your valuable household products are protected against expensive repairs. Place your confidence in GE and call us in the U.S. toll-free at for more information. *All brands covered, up to 20 years old, in the continental U.S.
-
Page 22: Serial Number
Check here if you do not want to receive communications from GEA’s carefully selected partners. FAILURE TO COMPLETE AND RETURN THIS CARD DOES NOT DIMINISH YOUR WARRANTY RIGHTS. For information about GEA’s privacy and data usage policy, go to ge.com and click on “Privacy Policy” or call 800.626.2224. Read your Owner’s Manual carefully. - Page 23 This warranty is extended to the original purchaser and any succeeding owner for products purchased for home use within the USA. If the product is located in an area where service by a GE Authorized Servicer is not available, you may be responsible for a trip charge or you may be required to bring the product to an Authorized GE Service location for service.
-
Page 24: Consumer Support
Caution must be exercised, since improper servicing may cause unsafe operation. Contact Us If you are not satisfied with the service you receive from GE, contact us on our Website with all the details including your phone number, or write to: General Manager, Customer Relations Register Your Appliance Register your new appliance on-line—at your convenience! Timely product registration will allow for...