Frigidaire 900 Series Use & Care Manual page 7

Operating Instructions
Status Indicator Lights
The SENSING light comes on at the
beginning of the selected cycle and will
remain on until the end of the sensing
sequence.
The WASHING light comes on at the
beginning of cycle and remains on until the
end of the main wash.
The RINSING light will come on and remain
on during the last two rinses of all cycles. If
RINSE HOLD is selected, the RINSING light
will remain on until the door is opened.
The DRYING light indicates the drying portion
of the cycle. The light will come on when
either drying option is selected.
The CLEAN light will come on at end of cycle
and remain on until door is opened.
Child Lock Controls
To prevent children from accidentally
changing the dishwasher cycle or starting the
dishwasher, lock the dishwasher controls by
pressing and releasing the POWER DRY OFF
pad, then pressing and holding the POWER
DRY OFF pad for 5 seconds. The
CONTROLS light will come on and no new
selections can be made until the lock is
released. To unlock the controls, press and
hold the POWER DRY OFF pad for 5 seconds
until the CONTROLS light goes out.
(continued)
Status Window
The STATUS window, available on some
models, indicates the following activity:
Note: The time remaining could suddenly
increase or drop several minutes. This means
the Smart Sensor has checked the soil level
and determined if additional water fills are
needed or if water fills can be deleted.
1H-9H ........ Number of delay start hours. The
last hour will count down in
minutes.
CL .............. Close dishwasher door. The
status indicator lights will also
flash to indicate current cycle
status.
HO ............. Flashes to indicate a water heat
delay.
MINUTES .. Number of minutes left in cycle
(1-99). If cycle is longer than 99
minutes, a small light will appear
in the lower right corner and
remain on until time counts below
99.
PF .............. Appears in window when
dishwasher is first installed, or
when power has been
interrupted. HI-TEMP WASH and
POWER DRY OFF indicator
lights will also flash. To clear,
touch START/CANCEL pad.
LO ............. Will be displayed at the end of the
cycle when the rinse aid
dispenser needs refilling. It will
remain on until the door is
opened and will appear after
completion of each cycle until the
rinse aid dispenser is filled.
7