Table of Contents
Advertisement
Installation and operating instructions
for HomEntry garage door opener
Model HE60R
Chamberlain Australia Pty Ltd
Phone toll free 1800 638 234
Fax toll free 1800 888 121
Chamberlain New Zealand Ltd
Phone toll free 0800 637 546
Fax toll free: 0800 653 663
www.homentry.com.au
This manual contains IMPORTANT SAFETY information.
DO NOT PROCEED WITH THE INSTALLATION BEFORE READING THOROUGHLY.
Advertisement
Table of Contents
Related Manuals for Homentry HE60R
Summary of Contents for Homentry HE60R
- Page 1 Installation and operating instructions for HomEntry garage door opener Model HE60R Chamberlain Australia Pty Ltd Phone toll free 1800 638 234 Fax toll free 1800 888 121 Chamberlain New Zealand Ltd Phone toll free 0800 637 546 Fax toll free: 0800 653 663 www.homentry.com.au...
- Page 3 Start by Reading These Important Safety Instructions WARNING: Failure to comply with the following instructions may result in serious personal injury or property damage. • Read these instructions carefully and follow ALL instructions carefully • The garage door opener is designed and tested to offer reasonable safe service provided it is installed and operated in strict accordance with the instructions in this manual.
- Page 4 Carton Inventory 1. Instruction manual (this document) 2. Stop bracket collar 3. Clamp bracket 4. Release handle and cord 5. Remote controls (2) 6. Extension poles (2) 7. Weight bar 8. Bracket plate 9. Hardware bag 10. Warning Labels (2) Tools Required 1.
- Page 5 Door Requirements The maximum allowable door height is 3.5m with a maximum curtain area of 8m² (door height in metres multiplied by the width in metres). The maximum allowable door weight is 60kg. Door area; h x w = m eg.
- Page 6 Testing the door Disable all locks and remove any ropes connected to the garage door. Complete the following test to ensure your door is well balanced, and not sticking or binding: • Lift the door to about halfway and then release it. The door should remain suspended entirely by its spring.
-
Page 7: Preparing The Opener
Preparing the Opener Set Opener Position (Left or Right hand) For left hand side installations For right hand side installations the wire jumper should be removed. the wire jumper should be in place (factory installed). Attaching the Extension Poles (if required) •... -
Page 8: Installation Steps
Installation steps FOR RIGHT HAND INSTALLATIONS (REFER SECTION 7, page 5) Ensure that the opener position jumper (wire connector) is • installed (refer Section 7, page 5). • Place the opener in manual release mode (refer Section 7, page • Open the roller door fully. For safety, tie a rope around the door. Ensure that the U-bolt on the left hand side of the door is secure . - Page 9 Attach the Release Handle and Cord • Thread one end of the rope through the hole in the top of the red handle so “NOTICE” reads right side up as shown. Secure with an overhand knot at least 25mm from the end of the rope to prevent slipping.
- Page 10 Setting the Limits The Travel Limits regulate the points at which the door will stop when moving UP or DOWN. During the SetUp procedure, the motor will run and operate the door. The Opener must be fully installed on the door and all installation steps completed before proceeding.
- Page 11 Setting the Force The force, as measured on the closing edge of the door, should not exceed 400N (40kg). If the closing force is measured to more than 400N, the Protector System must be installed. See Section 16. The force setting regulates the amount of power required to open and close the door.
- Page 12 Install this accessory for all installations where the SAFETY FIRST! closing force as measured on the bottom of the Whilst Chamberlain have engineered door is over 400N (40kgf). safety features into your garage door opener, we urge you to consider fitting...
- Page 13 Special Features • Multi function Control Panel Connect white/red wire to the red quick connect terminal and the white wire to the white quick connect terminal. • The Protector System™ (Safety Beams) Connect both white wires to the white quick connect terminal and both white/black wires to the grey quick connect terminal.
-
Page 14: Troubleshooting
Troubleshooting • Repeat the limit and force setting in Section 12 & 13, pages 8 & 9 . Repeat safety reverse test after 1. The opener doesn't operate from either the adjustments (Section 14 page 9). GREEN start button or the remote controls: •... -
Page 15: Maintenance Of Your Opener
• If an obstruction is encountered while closing, the door will reverse. • If an obstruction is encountered while opening, the door SPECIAL NOTE: Chamberlain strongly recommends that the will reverse and stop. protector system be installed on all garage door openers. - Page 16 Limited warranty on motor above, the Seller excludes all warranties and conditions Chamberlain will furnish a replacement motor free of charge, if it is implied by statute, at law, in fact or otherwise. found to be defective. Labour costs may apply.