Reversing The Door - GE DBB5000 Owner's Manual

About the dryer features.
About reversing the door.
8
Stainless Steel Drum
(on some models)
The stainless steel used to make the
dryer drum provides the highest reliability
available in a GE dryer. If the dryer drum
should be scratched or dented during

Reversing the Door

Tools needed:
s Standard #2
Phillips screwdriver
Open the door and remove the filler plugs opposite the hinges. With the door
1
completely open, remove the bottom screw from each hinge on the dryer face.
Insert these screws about half way into the TOP holes, for each hinge, on the
opposite side (where you removed the filler plugs). Apply firm pressure to get
the screw started in new holes.
Loosen top screw from each hinge on the dryer face half way. With one hand
2
holding the top of the door and the other hand holding the bottom, remove
the door from the dryer by lifting it UP and OUT.
Rotate the door 180° . Insert it on the opposite side of the opening by moving
3
the door IN and DOWN until the top hinge and the bottom hinge are resting
on the top screws inserted in step 1.
Remove the remaining screws from the side of the opening from which the door
4
was removed. With these screws secure each hinge at the bottom. Tighten the
two top screws of each hinge. Reinsert the plastic plugs on the side from which
the door was removed.
normal use, the drum will not rust or
corrode. These surface blemishes will
not affect the function or durability of
the drum.
s Tape-tipped
putty knife