Standby; Inger Hi/Low/Off; Call Waiting - GE 21018 User Manual

P -D
RE IALING
1. Make sure the phone is OFF (not in talk mode).
2. Enter the telephone number you want to call. The telephone number
shows in the handset display.
3. Press the TALK/END/CALLBACK button on the handset, and the number
automatically dials.
NOTE: You may enter up to 32 pre-dial digits.
NOTE: If you want to delete the pre-dial number you entered, press the DEL
button until all of the digits are erased.
A S
UTO TANDBY
If you place the handset in the cradle while the handset is off the hook
(during a call), the call is automatically disconnected.
R HI/LOW/OFF
INGER
There are two ways to set the ringer to HI/LOW/OFF . One is the traditional way
as described in the Programming Functions; Handset Setup; Ringer Volume
menus. The other one is this short cut to ringer menu.
1. Make sure the phone is OFF (not in talk mode).
2. Press the #PAUSE/RINGER button to display 1HI 2LOW 3OFF.
3. Use the touch tone pad on the handset to select 1, 2 or 3, or use the CID/
VOL (/\ or V) button to scroll to your selection. HI is the default setting.
4. Press #PAUSE/RINGER button again to save and display the new
selection for a few seconds.
F /C W
LASH ALL
If you subscribe to the combined Call Waiting Caller ID service from your
local telephone company, you will receive Caller ID information (if available)
on Call Waiting calls. During a phone call, you will hear a beep to indicate
another call is waiting on the line and Caller ID information for the waiting
call shows on the handset display.
• To connect to the waiting call, press the FLASH button on the handset,
and your original call is put on hold.
AITING
21