Service; Warranty; Maintenance - Cello Encore Amplifier Owner's Manual

Instructions, cont.
The following bridged operation
instructions are for connecting one pair
of amp units (one channel).
1) With power "OFF" connect AC cord
as instructed in Encore Amplifier
manual.
2) Connect input to one amplifier only.
We will call this amp unit "Amp 1."
The second amp unit will be called
"Amp 2."
3) Connect the input jumper cable,
included in the bridging kit, from the
"
bridging connector of
Amp 1
"
"
input of Amp 2.
Both are labeled on
the rear panel of your Encore unit.
4) Connect one speaker's positive (+) or
high lead (usually marked in red) to
the output terminal labeled "H"
( High) of "Amp 1."
5) Connect the same speaker's negative
(-) or low lead (usually marked in
black) to the output terminal labeled
"H" (High) of "Amp 2."
6) Connect the output ground jumper
cable, included in the bridging kit,
from the output terminal labeled "L"
(Low) of "Amp 1" to the output
terminal labeled "L" of "Amp 2."
This channel is now ready for
operation.
To connect for stereo, simply repeat
the procedure in steps 1-6 on the second
set of amps.
CAUTION: Make certain preamplifier
volume is turned down before AC
power of bridged amplifiers is
switched "ON."

SERVICE

Do not attempt to modify the Encore
Amplifier. Should you have any ques-
tions or problems with your Encore,
please contact Cello's Customer Service
Department and allow us to assist
If your Encore requires service, this
department will provide you with a
Return Authorization (R.A.) number and
instructions on how to return your unit
to the factory. All returns to the factory
require an assigned R.A. number.
"
to the
Returns received without original
packing will be shipped out in Cello
cartons at owner's expense. Replace-
ment packing materials are available
by calling the Customer Service
Department.
CELLO LIMITED WARRANTY
Parts: Five years 100% coverage for
all parts.
Labor: Five years 100% coverage for
all labor.
Shipping: One year 100% coverage for
all shipping and insurance charges pre-
paid to and from the factory from
anywhere in the world via reasonable
carrier. (Note: Special freight or rush
shipments will incur customer charge.)
After one year, units coming into the
factory must arrive with shipping
charges pre-paid. Return shipping
charges will be paid by the factory.
Warranty of Replacement Parts from
the factory: The remainder of the
warranty period for the unit or one year
ENCORE TRUE DUAL MONO AMPLIFIER
( whichever is longer) shall be the
warranty applied to any replacement
part(s) issued.
Warranty of Repair Work Performed:
Any specific repairs or modifications
you. effected by the factory or authorized
service facility shall be guaranteed for
100% parts and labor for the remainder
of the warranty period for the unit or
one year (whichever is longer).
Transferability: All of the above war-
ranties are transferable to any succession
of subsequent owners. Please contact
your nearest Cello Designer or the
Customer Service Department at the
factory for details of subsequent owner
warranty registration.
Tampering: Any unauthorized modifi-
cations, repairs or tampering with any
Cello product will void its warranty.
Abuse/Misuse: Any indications of
obvious owner abuse, negligence or
i mproper usage, as determined by the
factory, shall void the warranty.

MAINTENANCE

The finish of the Encore Amplifier is of
brushed and anodized aluminum.
Ammonia-based glass cleaner or alcohol
and a soft cloth work well to restore
the shine and remove finger prints. Be
sure that the unit is off and unplugged
before cleaning. Avoid getting excess
cleaning fluid inside the amplifier. Take
care when cleaning rear panel. Do not
rub so hard as to remove the silkscreen
lettering.
5