Alpine iDA-X300 Owner's Manual page 40

<JAPANESE CAR>
This unit
iPod Connection (sold separately)
USB connection (iDA-X200 only)
Connect USB cable to an iPod with iPod Dock interface cable.
iPod Dock interface Cable (supplied, iDA-X200 only)
Direct connection
Connect iPod direct connector to an iPod with FULL SPEED™
connection cable (KCE-422i).
FULL SPEED™
Connection Cable
(KCE-422i)
(sold separately)
38
-EN
Front Frame
Screws (M5 × 8)
(Included)
Mounting Bracket
USB cable
Remove the iPod
Remove the iPod from FULL SPEED™ Connection Cable (or
iPod Dock interface cable (iDA-X200 only)).
• If USB is connected, after the unit has been changed to a source
other than the iPod, remove the iPod. If the iPod is removed in the
iPod mode, data may cause damage.
• If sound is not output or the iPod is not recognized even when the
iPod is connected, remove the iPod once, then connect it again, or
reset the iPod.
USB memory Connection (sold separately)
Connect USB memory
Connect USB memory to USB cable.
This unit
USB connector
Remove USB memory
Pull out USB memory squarely from the USB cable.
This unit
USB connector
Cable (supplied)
• When removing USB memory, pull it out straight.
• If sound is not output or USB memory is not recognized even when
USB memory is connected, remove USB memory once, then connect
it again.
• Change to a source other than the USB memory mode, then remove
the USB memory. If the USB memory is removed in the USB memory
mode, data may be damaged.
• Route the USB cable away from other cables.
Portable Audio Player Connection (sold separately,
iDA-X200 only)
Connecting a Portable audio player
Connect the cable supplied with a Portable audio player to
the USB cable.
Disconnect the Portable audio player.
Disconnect the cable supplied with the Portable audio
player from the USB cable.
• Refer also to the Owner's Manual of the Portable audio player.
USB memory
(sold separately)
Cable (supplied)
USB memory
(sold separately)