NEC Express5800 320La Installation Notes page 6

11. The SP3 CD brings up an information window. Close the information
window by clicking the "X" in the upper right hand corner of the display.
12. Click Yes on the displayed dialog box. The relevant files for the 320La
server are extracted from the CD.
13. When the Service Pack 3 Setup Wizard window displays, click Next.
14. Click the "I Agree" radio button, and then click Next.
15. Choose to archive or not archive files (this choice is up to local
administration policy). The default is to archive files. Click Next. The
Service Pack 3 installation begins.
16. Click Finish to begin the installation of the Service Pack 3 update.
17. Insert the EXPRESSBUILDER CD when prompted.
18. Close the EXPRESSBUILDER window by clicking the "X" in the upper
right hand corner of the display.
19. Click OK at the Setup Message dialog box.
20. Another dialog box displays, click OK.
21. Microsoft OS updates and 320La specific updates are installed.
Note
five to seven minutes. At times it may seem that the process
has stalled. However, the system is still actively processing
the updates.
22. At the completion of the batch process, remove the EXPRESSBUILDER
CD. The system will reboot.
Note
23. After the Reboot, the Found New Hardware wizard may run. If it does, click
on all defaults to complete the process. If prompted to restart Windows, DO
NOT RESTART the system.
24. Check disk mirroring, if disabled, enable it again. During disk
resynchronization, DO NOT shut down the system.
4 Express5800/320La Service Pack 3 Installation Notes
: The batch process installing the updates runs for
: The system reboots without user intervention.
Start/settings/control panel/administrative tools/computer
management/
Click on Storage.
Click on Disk Management.
Select "Veritas Volume Manager" and then Select "Disk View."
Check if Disk Mirroring is enabled.