Replacing The Rear Fan Assembly - Lenovo THINKSTATION 7782 User Manual

Hide thumbs Also See for THINKSTATION 7782:

Table of Contents

6. Insert the two tabs

press the other two tabs

Figure 33. Installing the front fan assembly

7. Connect the front fan assembly cable to the front fan connector on the system board. See "Locating

parts on the system board" on page 11.

What to do next:

• To work with another piece of hardware, go to the appropriate section.

• To complete the installation or replacement, go to "Completing the parts replacement" on page 49.

Replacing the rear fan assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the "Important

safety information" on page iii.

This section provides instructions on how to replace the rear fan assembly.

To replace the rear fan assembly, do the following:

1. Turn off the computer and disconnect all power cords from electrical outlets.

2. Remove the computer cover. See "Removing the computer cover" on page 26.

3. Locate the rear fan assembly. See "Locating components" on page 10.

ThinkStation User Guide

of the new front fan assembly into the corresponding holes in the chassis, and

through the holes until the front fan assembly is secured in place.

Table of Contents