Viking built-in Installation, Use & Care Manual page 17

Special note for the turntable and turntable Support
To avoid arcing, carefully read before placing the turntable support and
turntable into the oven.
1. Place the turntable support, with the engraved word "Top" facing up,
securely within the three pins on the turntable motor shaft. See Figure 3
to check for the correct placement.
Figure 1
Turntable support
Turntable motor shaft
2. Place the turntable on the turntable support. The turntable should be
placed so that all three rollers of the turntable support come in contact
with the flat, underside surface of the turntable. Refer to the chart below
to ensure correct placement.
Underside
View
Side View
CORRECT
Flat surface of the turntable
Rollers of the turntable support
Flat surface of the turntable
Rollers of the turntable support
Figure 2
Flat surface of the turntable
Flat surface of the turntable
Rollers of the turntable support
15
Figure 3
Turntable support
The pins of the turntable
motor shaft
INCORRECT
Not on flat surface
E