GE AJCM 10 Owner's Manual page 18

WINDOW INSTALLATION—OPTIONAL (cont.)
PREPARE WINDOW
4
Mark the centerline of the stool. Measure from the
A
" on both sides for the panel cuts.
centerline 13 3 ⁄
8
Sill
13 3
Stool
5 INSTALL SILL SUPPORTS
Assemble the sill supports. Do not fully tighten
A
the spacer mounting screws at this time.
Type B
Type E
Sill support
Lock nut
Adjusting bolt
Large washer
(for use with wood sills)
Before attaching the sill supports, place them on
B
the window stool. Select the spacer position that
will place the spacer near the outermost point
on the sill. Tighten the spacer mounting screws.
Screws are in position
Sill support
"V" notch
Sill
Installation Instructions
Centerline
Outside
"
"
13 3 ⁄
⁄
8
8
Inside
Spacer mounting
screws Type (A)
Spacer
Inside
Stool
Bolt
Outside
" from the centerline on both sides
Measure 12 3 ⁄
B
8
for the sill support brackets.
Sill
12 3 ⁄
Stool
Turn the bolts and tighten the lock nuts to make
C
the sill supports level or tilt down 1/8" to the outside.
Line up the "V" notch with 12
and attach the sill supports.
Sill support
Offset sill (such as brick or stone)
OTES:
N
• On narrow sills, there may not be enough room to use
the lock nut.
• A deep offset sill may require a longer adjusting bolt
than the standard hex-head bolt provided.
• On wood sills use the large washer between the bolt
head and the sill. This prevents the bolt from digging
into the wood.
18
Centerline
Outside
"
"
12 ⁄
3
8 8
Inside
" marks. Drill pilot holes
3 ⁄
8
Average sill
Spacer
Narrow sill