Troubleshooting Tips; Before You Call For Service - GE AGE12 Owner's Manual And Installation Instructions

Ge air conditioner owner's manual and installation instructions age12
Table of Contents

Advertisement

Before you call for service...

Troubleshooting Tips

Save time and money! Review the chart below first
and you may not need to call for service.
Problem
Air conditioner
does not start
Air conditioner
freezing up
Air conditioner does not
cool as it should
Air conditioner does not
warm as it should
Possible Causes
The air conditioner
is unplugged
The fuse is blown/circuit
breaker is tripped
Power failure
Ice blocks the air flow
and stops the air conditioner
from cooling the room
Airflow is restricted
The temp control may
not be set correctly
The air filter is dirty
The room may have been hot
Cold air is escaping
Cooling coils have iced up
Airflow is restricted
The temp control may
not be set low enough
The air filter is dirty
The room may have been cold
Warm air is escaping
What To Do
• Make sure the air conditioner plug is pushed completely
into the outlet.
• Check the house fuse/circuit breaker box and replace
the fuse or reset the breaker.
• If power failure occurs, turn the air conditioner OFF.
When power is restored, wait 3 minutes to restart the
air conditioner to prevent tripping of the compressor
overload.
• Set the mode control at FAN or HIGH COOL with the
temp control at a warmer setting.
• Make sure there are no curtains, blinds or furniture
blocking the front of the air conditioner.
• Turn the temperature knob clockwise as far as possible.
• Clean the filter at least every 30 days. See the Operating
Instructions section.
• When the air conditioner is first turned on you need
to allow time for the room to cool down.
• Check for open furnace floor registers and
cold air returns.
• Set the air conditioner's vent to the closed position.
• See "Air conditioner freezing up" below.
• Make sure there are no curtains, blinds or furniture
blocking the front of the air conditioner.
• Turn the knob counterclockwise as far as possible.
The lowest setting provides maximum warming.
• Clean the filter at least every 30 days. See the Operating
Instructions section.
• When the air conditioner is first turned on, you need to
allow time for the room to warm up.
• Check for open furnace floor registers and
cold air returns.
www.GEAppliances.com
13

Advertisement

Table of Contents
loading

Table of Contents