Connecting The System Components; Switching On And Using The Stethoset Receiver; Switching The Stethoset Receiver Off; Charging The Stethoset Receiver - Sennheiser Quickguide RS 4200 Quick Instructions

Quick instructions
RS 4200
µ
¶
²
´

Connecting the system components

Plug in one end of the connecting cable
If necessary, use one of the adapters
Plug in the other end of the connecting cable
¾
Align the antenna
Connect the mains unit
Place the receiver into the transmitter's charging compartment µ.
Before you use the rechargeable battery
Adjust the volume on your sound source to a sufficient (medium) level.

Switching on and using the stethoset receiver

The receiver automatically switches on when you pull the earbows apart.
First adjust the volume to a low level. This protects your hearing from damage.
Then put the receiver on and adjust the volume to a comfortable level.
If reception is subject to interference, press the
Use the balance control
If you cannot hear anything through the receiver, increase the volume on your sound
source.

Switching the stethoset receiver off

The receiver automatically switches off when you take it off.
Charging the stethoset reciever
Place the receiver into the transmitter's charging compartment
pressure. With a fully charged battery, the operating time is approx. 9 hours.
For details on the use of the RS 4200, please refer to the enclosed operating instructions.
¾
A
B
C
to the socket on your sound source (e.g. television).
,
vertically.
to the transmitter
·
»
to adjust the volume between the left and right ear.
or (not included).
to the blue socket
and to the mains.
for the first time, charge it until the LED
button ¿.
TUNE
µ
»
·
³
on the transmitter.
lights up green.
without exerting too much
¿