Scanning The Channel Banks For Free Channels (Em 300 G2 Only) - Sennheiser ew 300 G2 Instructions For Use Manual

Scanning the channel banks for free channels
(EM 300 G2 only)
Scan
Before putting one or several transmission links into operation, you should
scan the channel banks for free channels.
Displaying the last scan result
Scan
Channel list
Scan new
Scan reset
1 2 3 4
Bank
08 08 03 04
Free
5 6 7 8 U
Bank
06 08 02 01 08
Free
Channel
1.01
786.300 MHz
B.CH
Starting the scan
Scan
Channel list
Scan new
Scan reset
1 2 3 4
Bank
Free 08 08 03 04
5 6 7 8 U
Bank
06 08 02 01 08
Free
Releasing locked channels
Scan
Channel list
Scan new
Scan reset
1 2 3 4
Bank
Free 08 08 08 08
5 6 7 8 U
Bank
08 08 08 08 08
Free
Select the "Scan" menu.
Select "Channel list" to display the last scan result. The number of free
channels is displayed for all channel banks.
For further details, select a channel bank by using the
then press the SET button. This gets you into the "Channel" menu where
you can select a channel of this channel bank or display the frequency of
a channel.
Before starting the scan, switch all transmitters of your system off, since
channels used by switched-on transmitters will not be displayed as "free
channels".
Select the "Scan" menu.
Select "Scan new" and confirm your selection by pressing the
After the scan is completed, the number of free channels is displayed for
all channel banks. Channels that are used or subject to interference are
locked and cannot be selected.
For further details, select a channel bank by using the
then press the SET button. This gets you into the "Channel" menu where
you can select a channel of this channel bank or display the frequency of
a channel.
Select the "Scan" menu.
Select "Scan reset" and confirm your selection by pressing the
The last scan result is deleted and all channels can now be selected again.
/ buttons and
SET button.
/ buttons and
SET button.
29