Sennheiser EM 3731 Instructions For Use Manual page 79

save
DEV 790.800
M
H
z
sync
03.03
BANK AF
COM
esc
CH
AF Out
+12 dB
save
790.800
DEV
M
H
z
sync
03.03
BANK AF COM
esc
CH
44.1
48
kHz
88.2
96
Ext.
save
DEV 790.800
M
H
z
sync
03.03
BANK
AF COM
esc
CH
Change the setting to "Booster Feed On" or "Booster Feed Off" by
turning the jog dial
Press the save
digital audio
processing
The selected setting is stored. When the booster supply voltage is
sync
switched on, the two LEDs
the selection mode of the operating menu.
Adjusting the audio output level
Via the "AF Out" menu, you can adjust the output level of the audio
outputs (AF out and Command).
With the EM 3732 Command, the audio level of the Command output 1
corresponds to the level of the audio output 1
Command output 2
The following figures are a guide to the best settings:
Line input level:
Microphone input level:
Note:
to obtain the best signal-to-noise ration, adjust the input level to
+18 dB or +4 dB.
Change to the setting mode of the
The current setting starts flashing.
+12
Adjust the audio output level by turning the jog dial
The display shows the selected audio output level.
Press the save
digital audio
processing
The selected setting is stored. The display changes to the selection
sync
mode of the operating menu.
Selecting the sampling rate for digitalization
Clock Via the "Clock" menu, you can select the sampling rate with which the
analog signal is digitalized and output via the digital balanced XLR-3M
G
audio output . You can choose between the sampling rates "44.1 kHz",
"48 kHz", "88.2 kHz", "96 kHz" and "Ext.". "Ext." means that the receiver
will use one of above sampling rates from the external word clock
generator. In this case, you first have to connect an external word clock
generator to the BNC socket
generator" on page 18) and switch it on.
Change to the setting mode of the "Clock" menu.
The current setting starts flashing.
48
Select the desired sampling rate by turning the jog dial
Press the save
The selected sampling rate is stored. The display changes to the
digital audio
processing
selection mode of the operating menu.
sync
7
.
8
button .
N S
and light up. The display changes to
K
corresponds to the level of the audio output 2
+5 to +18 dB
–10 to
"AF Out" menu.
8
button .
H
(see "Connecting an external word clock
8
button .
The operating menu
M
N
and the audio level of the
L
+4 dB
7
.
7
.
31
.