Cobra 29 LX CAMO User Manual page 3

Installation
Note
Before installing the CB radio,
visually check the vehicle's
battery connection to deter-
mine which terminal, positive
or negative, is grounded (pos-
itive is the larger of the two)
to the engine block (or chas-
sis). A negatively grounded
vehicle has its negative lead
grounded to the chassis.
Note
Connecting to an accessory fuse
prevents the unit from being left
on accidentally, and also per-
mits operating the unit without
running the engine.
4 In a negative grounded vehicle, connect the
Note
red lead of the DC power cord to an accessory
In positive ground vehicles the
12 volt fuse.
red wire goes to the chassis and
the black wire is connected to
Connect the black lead to the negative side
5
the ignition switch.
of the vehicle. This is usually the chassis. Any
convenient location with a good electrical
Note
contact (remove paint) may be used.
When connected to an acces-
sory fuse, unit will self test
the emergency weather alert
automatically when ignition
is turned on. Turns itself on & off.
4
Plug power cable into back of unit marked
6
"Power". Be sure to observe polarity markings.
7 Mount the microphone
bracket on either side
of the unit (driver's left)
using two screws sup-
plied. Bracket should be
placed under the dash
so microphone is readily
accessible.
8
Attach the 4-pin microphone cable to
receptacle on front of unit and install unit
in bracket securely.
Installation
Note
If microphone is not
connected, audio will not
be heard at speaker.
5