Table of Contents
Advertisement
Pair Remote
Remote pairing is a process where the Responder LC remote, and the
in-vehicle system learn the other's encrypted identification, securing
communication between the two from intruders.
Note: Remotes are pre-programmed from the factory.
Prepare the vehicle system to be Paired with a new remote
1.
Turn
the key to the On position.
2.
Within 5 seconds
the Control Center.
3.
Within 5 seconds,
LED will flash one time and the horn will honk once to confirm the
system is ready for remote pairing.
4.
Release
Note: If pairing does not result within 60 seconds, the system exits
and the horn honks.
Prepare the new remote to be Paired with the system
1.
Make sure the remote control is set for the desired Car 1 or Car
2 operation.
2.
Perform the steps under
Pair Remote mode.
3.
When the remote beeps 3 times and
remote is ready to pair.
Press
and hold the
4.
will emit several tones to confirm successful pairing.
displayed and the remote returns to the main menu.
Note:
failed
mode in case of an unsuccessful pairing. Check the system status and
try again.
26
press and release 1 time the Control button on
press and hold the Control button. The status
the Control button and proceed below.
button, the horn honks once and the remote
AUX
will be displayed and the remote will stay in the pair
Access menu items section to access the
AUX
© 2009 Directed Electronics. All rights reserved.
is displayed the
pair
success
is
Advertisement
Table of Contents
