Advertisement
Advertisement
Table of Contents
Related Manuals for Boss Audio Systems MR1440U
Summary of Contents for Boss Audio Systems MR1440U
- Page 2 Preface Thank you for purchasing this car audio product. Please read this manual carefully before operating this car audio product. Please keep this manual for future use. It will be helpful to you if you are encounter any operational problem. Selecting fine audio equipment is only the start of your musical enjoyment.
-
Page 3: Specification
LOCATION AND FUNCTION OF CONTROLS SPECIFICATION 9 10 GENERAL Supply Voltage DC 12 V. Negative Ground MUTE LOUD Current Consumption Max.7.5A Power Output 4 X 60watts high power Number of channels 2 STEREO channels. Unit Dimensions 7[W] X 6.5[D] X 2[H] mm. FM SECTION MODE Frequency range... -
Page 4: Troubleshooting
b) When pressed and hold for 2 seconds, it is activated as cyclical mode of TROUBLE SHOOTING ’ following functions for user s selection. ->BEEP (ON/OFF) -> USER SET(FLAT/CLASSIC/ROCK/POP) Before using the check list please make all the connections first. ->SUBW(ON/OFF)->VOL(LAST/DEFA) ->CLK(ON/OFF)->CLK(12/24)mode. -
Page 5: Care For Using Cd's
7. BAND BUTTON CARE FOR USING CD'S: During radio mode, press the BND button briefly to select the radio broadcasting band you would like to hear. The AM/FM band is toggled cyclically through the About CD-R/CD-R/W discs: tuning bands: ->FM 1-> FM 2 -> FM 3 -> AM 1->AM2 ->. In addition to commercially-recorded audio CD's, this unit can play CD-R and CD-R/W discs. -
Page 6: Installation
12. PRESET STATION MEMORY AND TOP/>||, INT, RPT, RDM BUTTONS INSTALLATION a) During radio mode: Go to any preset station by pressing one of the 6 preset station buttons (1-6). If one of these buttons is pressed for more than 2 seconds, the station currently INSTALLATION METHOD being listened to will be memorized into the selected preset button. -
Page 7: Wires Connection
WIRES CONNECTION 17. SCAN BUTTON Press the SCN button to scan the radio frequency. If a valid signal has detected, RCA LINE OUT RCA LINE OUT the current frequency will be hold and blinking for 5 seconds, then press SCN REAR RIGHT SPEAKER JACK FRONT RIGHT SPEAKER JACK again to stop scan and remain the current frequency;... -
Page 8: Operation Of Remote Control
MAINTENANCE OF REMOTE CONTROL OPERATION OF REMOTE CONTROL An insulation tag was installed in your remote by the manufacturer to prevent the 1. Power On/Off battery from draining. Removing the tag from the remote before using. 2. Mute Button Loudness Button MUTE SELECT 4.
Need help?
Do you have a question about the MR1440U and is the answer not in the manual?
Questions and answers