Adjusting Tilt (Vertical Viewing Angle) Tension - Gateway FPD1785 User Manual

Using Your Gateway Flat Panel Monitor

Adjusting tilt (vertical viewing angle) tension

6
Adjust the height tension screw so raising and lowering forces are equal.
3
After the forces are equalized, turn the tension screw clockwise 2 to 4 turns
to slightly decrease the lifting tension.
For optimum viewing, adjust the height so the top of monitor is about
4
1 inch below eye level.
To test and adjust tilt tension:
Tilt the monitor back and forth through its entire tilt range. If it does not
1
stay in place or if movement in one direction is stiff, the tilt tension needs
adjustment.
Pull the black rubber cover away from the top of the stand, then hold it
2
back with one hand.
To increase tilt tension, turn the screw clockwise with a Phillips
3
screwdriver. To decrease tilt tension, turn the screw counter-clockwise.
Adjust until the monitor stays in place and the up and down tilting
tensions are equal.
www.gateway.com
Increase tilt tension (clockwise)
Decrease tilt tension
(counter-clockwise)