Assigning Menus To Function Keys; To Assign A Menu Screen To A Key; Recalling An Assigned Menu Function - Tascam DA-98 Owner's Manual

Section 5 – Menu operations
5) Press the key [22] (to enter a ):
F 10
6) Press the F 5 key [13]:
7) The numbers for this value have now been
entered, but the value itself has not. Press the
key [23] to enter the value.
LOC 2 (PRESET)
The bottom line of the display will stop blinking.
8) You can use the
UP
the value you have just entered.
9) Press again to restore the function keys
SHIFT
to their "non-function" values.
NOTE
Some parameters (e.g. offsets) can take either positive
or negative values. To change the sign of the value, use
MEMO 2 (+/–)
the
tive and negative values.
You can use the function keys as number keys in
almost any menu where direct numerical input is
possible.
You cannot use these keys as number keys when
there are only two choices (even if they are
numerical). An example of such a menu is the
two options for the
and 2 seconds. This parameter should be set using
the and keys, not the number keys.
UP DOWN
5.3 Assigning menus to
function keys
It is quite likely that you will find yourself using a
few of the same menu functions many times (for
instance, manual adjustment of punch points) and
5-4 – 1.00 – 06/97
and keys to adjust
DOWN
key [14] to toggle
between posi-
menu (page 10-13), where the
value are 1 second
many of the menu functions only rarely (for
instance, whether the DA-98 is a master or a slave
unit).
Some of the keys below the tape counter ([9]
through [13], and [18] through [22]) can be used
as "soft keys", providing instant access to the
menu screens you use most often.

5.3.1 To assign a menu screen to a key

1) Set the function key mode to
described in 5.2, "Function key modes"
2) Use the cursor and
menu function you want to assign to a key.
3) Press the key [24] (the indicator will
SHIFT
flash).
4) Press the key [23]. The following will
PRESET
appear on the display.
5) Press the key ( through
F 1
want to assign the menu screen.
This will assign the menu screen to the key and the
SHIFT indicator will go out.
5.3.2 Recalling an assigned menu
function
1) Press the [24] key (the indicator will
SHIFT
flash).
2) Press the key ( through
F 1
assigned to the menu function you want to
recall.
The menu screen will be recalled, and the SHIFT
indicator will go out.
as
keys to get to the
ENTER
) to which you
F 10
) which has been
10