Power Button Menu - Intel D34010WYB Update Manual

Intel NUC Board D54250WYB and Intel NUC Board D34010WYB
Technical Product Specification
3.7.4

Power Button Menu

As an alternative to Back-to-BIOS Mode or normal POST Hotkeys, the user can use the
power button to access a menu. The Power Button Menu is accessible via the following
sequence:
1. System is in S4/S5 (Not G3)
2. User pushes the power button and holds it down
3. The system will emit three short beeps from the PC speaker, then stop to signal the
user to release the power button
4. User releases the power button before the 4-second shutdown override
If this boot path is taken, the BIOS will use default settings, ignoring settings in VPD
where possible.
At the point where Setup Entry/Boot would be in the normal boot path, the BIOS will
display the following prompt and wait for a keystroke:
[ESC] Normal Boot
[F2] Intel Visual BIOS
[F3] Disable Fast Boot
[F4] BIOS Recovery
[F7] Update BIOS
[F9] Remote Assistance
[F10] Enter Boot Menu
[F12] Network Boot
[F2] Enter Setup is displayed instead if Visual BIOS is not supported.
[F3] Disable Fast Boot is only displayed if at least one Fast Boot optimization is
enabled.
[F9] Remote Assistance is only displayed if Remote Assistance is supported.
If an unrecognized key is hit, then the BIOS will beep and wait for another keystroke.
If one of the listed hotkeys is hit, the BIOS will follow the indicated boot path.
Password requirements must still be honored.
If Disable Fast Boot is selected, the BIOS will disable all Fast Boot optimizations and
reset the system.
62