Page 1
Additional Digital Cordless Handset KX-TGA807E Model No. This unit is an additional handset for use with the following Panasonic Digital Cordless Phones: KX-TG8070/KX-TG8090 You must register this handset with your base unit before it can be used. This installation manual describes only the steps needed to register and begin using the handset.
TGA807E(e).fm Page 2 Monday, April 16, 2007 6:17 PM Thank you for purchasing a new Panasonic digital cordless phone. Additional/replacement accessories Model No. Description 2 rechargeable nickel metal hydride (Ni-MH) batteries, P03P AAA (R03) size *1 Replacement batteries may have a different capacity from that of the supplied batteries.
Page 3
TGA807E(e).fm Page 3 Monday, April 16, 2007 6:17 PM - the key lock feature is turned on. • Do not open the charger or handset other than to replace the battery(ies). • This product should not be used near emergency/intensive care medical equipment and should not be used by people with pacemakers.
TGA807E(e).fm Page 4 Monday, April 16, 2007 6:17 PM • Exercise care when handling the battery(ies). Do not allow conductive materials such as rings, bracelets or keys to touch the battery(ies), otherwise a short circuit may cause the battery(ies) and/or the conductive material to overheat and cause burns.
TGA807E(e).fm Page 5 Monday, April 16, 2007 6:17 PM Connection The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.) Location • For maximum distance and noise-free operation, place your base unit: - away from electrical appliances such as TVs, radios, personal computers or other phones.
TGA807E(e).fm Page 6 Monday, April 16, 2007 6:17 PM Insert the batteries negative (T) end first. Close the handset cover. Rechargeable Ni-MH ONLY Battery charge Place the handset on the charger for about 8 hours before initial use. Note: • The handset display may show “Register!” when the handset is placed on the charger if it is not registered to a base unit.
Page 7
“Enter PIN” is displayed. Enter the base unit PIN (default: “0000”). i {OK} • If you forget your PIN, consult your nearest Panasonic service centre. • When the handset has been registered successfully, w will stop flashing. If the key tone is turned on, a confirmation tone will be heard.
Page 8
1-62, 4-chome, Minoshima, Hakata-ku, Fukuoka 812-8531, Japan Copyright: This material is copyrighted by Panasonic Communications Co., Ltd., and may be reproduced for internal use only. All other reproduction, in whole or in part, is prohibited without the written consent of Panasonic Communications Co., Ltd.