Using The Clock And Timer - LG LRG30855ST User Manual

OPERAliNGiNslRUcliONs
USING THE CLOCK AND TIMER
HOW TO SET THE CLOCK
The clock must be set to the correct time
of day for the automatic oven timing functions
to work properly. The time of day Cannot
be Changed during a timed baking or
self-cleaning cycle.
I_ Touch the CLOCK pad once
to set.
_ Touch the number pads to enter
-- the time. Touch the number pads
the same way you read them. For
example, to set 12:34, touch the
number pads 1, 2, 3, and 4 in
that order.
If number pads are not touched
within one minute after you touch
the CLOCK pad, the display
reverts to the original setting. If
this happens, touch the CLOCK
pad and reenter the time of day.
O Touch the START pad until the
time of day shows in the display.
This enters the time and starts
the clock.
To check the time of day when the display is
showing other information, simply touch the
CLOCK pad.
HOW TO SET THE TIMER
The timer does not control oven operations.
The maximum setting on the timer is 9 hours
and 59 minutes.
Touch the TIMER ON/OFF pad.
_ Touch the number pads until the
amount of time you want shows in
the display. The maximum time
that can be entered in minutes is
59. Times more than 59 minutes
should be changed to hours and
minutes. For example, to enter 90
minutes as 1 hour 30 minutes,
touch 1,3, and 0 in that order.
NOTE: If you make a mistake,
press the TIMER ON/OFF pad
and begin again.
O
Touch the START pad. After
pressing the START pad, SET
disappears; this tells you the time
is counting down, although the
display does not change until one
minute has passed.
_When the timer reaches the
,00,
control will beep 3 times followed
by one beep every 6 seconds until
the TIMER ON/OFF pad is
touched.
The 6 second tone can be canceled by following the
steps in the Special Features of Your Oven Control
section under Tones at the End of a Timed Cycle.
NOTE: The timer is a minute timer only. The
CLEAR/OFF pad does not affect the timer.
HOW TO RESET THE TIMER
If the display is still showing the time remaining,
you may change it by touching the TIMER
ON/OFF pad, then touch the number pads until
the time you want appears in the display.
If the remaining time is not in the display (clock,
delay start or cooking time are in the display),
recall the remaining time by touching the TIMER
ON/OFF pad and then touching the number
pads to enter the new time you want.
HOW TO CANCEL THE TIMER
Touch the TIMER ON/OFF pad twice.
POWER OUTAGE
If a flashing time is in the display, you have
experienced a power failure. Reset the clock.
Touch the CLOCK pad once to reset. Enter the
correct time of day by touching the appropriate
number pads. Touch the START pad.