GE EGR2000 Owner's Manual & Installation Instructions page 48

,O
m
. !
w
m _r_
n
m
w
m
m
i_iiiiiiiiiiY_]iiiiiiii_i]i
ii;_!i;:;:'!iiii/iliii
m
I
Before you call for service...
Troubleshooting -tips
Excessive smoking
Possible Causes
Excessive soil.
What To Do
• On models with loud/pads, loud/tile Clear/Off pad.
On models with an OVEN TEMPknob, mrn it to OFF.
Open the windows to rid the room of smoke. _'_ait m]fil
the
SELFCLEANlight goes
off. _4"ipe up the
excess soil
and reset the clean cycle.
Oven door willnotopen Oven too hot. • _Mlow the oven to cool below locking temperatm'e.
after a clean cycle
Oven not clean after Oven controls not properly set. • See the Using the self-cleaning oven section.
a clean cycle Oven was heavily soiled. • Clean up heavv, sl_illove_ heft)re stnrting, the clean cycle.
Heavily soiled ovens ma_ need to sell_clean again or fin.
a longer period of time.
Oven door will not Oven is too hot. • _Mlow the oven to cool below locking temperatm'e.
unlock (on models Do not lock the door with the door latch except when
with a doorlatch)
usin*_ the self:clean teatm'e.
Self clean light (on
The
OVEN TEMP knob
has not
• Set
the
OVEN TEMP knob to CLEAN. See
the
Using the
some
models)blinks
been
set to CLEAN when
the
self-cleaning
oven section.
when trying
to set a latch was moved to the fight.
self clean cycle
The latch was not moved to the * Move the latch t(> the right as far as it will _ re See the
fight when the
OVENTEMP
knob
Using the self-cleaning
oven section.
was set to CLEAN.
Self clean light (on A power interruption occurred, oTurn the OVEN TEMP knob to OFFand move the latch
some models) blinks to the left as t.H" as it will go. Reset the range controls
during self clean cycle
to the desired
settings.
See the Using the self-cleaning
oven section.
"Door"appears in the Self-clemah_g cycle has been • Move the latch handle all the wa_ to the right.
display (on
some models_ selected but the latch handle
was not moved all the way
to the fight.
Latch hm_dle was moved to the
fight but a progrmn other than
self-clem_h_g was selected.
• Moxe the latch handle to the right on b when ,setfino
the sel6cleaning cycle.
"F--and a number or On models with a door latch, • The latch may have been m()ved, eveu if only slightly,
letter"flash in the display if a function error code appears fl'om the locked position. Make sure the latch is moved
ton some models/ durh_g the self-clemah_g cycle, to the right as thr as it will go.
check the oven door latch.
You have a function error code. • Touch the Clear/Off pad. _Mlow the oven to cool fin"
one hem: Put the oven back into operation.
If the function code repeats. • Discom_ect all power to the range fi)r 5 minutes
and then recoIn]ect l)owe_:/f the flu]ction error
code repeats, call for service.
48