System Test; Installer Setup - homexpert THR872CUK User Manual

Installation and Setup

System test

Press OFF, check heating unit After installation, you should check to make sure the system is
working properly.
Thu 30/12/10
1 Press the thermostat OFF button.
23.
°
12:34
PM
5
2 Check the power supply to make sure the system is on and the
Room Temp
green light on the relay box is off.
AUTO MAN OFF 3 Press the thermostat MAN button, then press the p button to
raise target temperature to maximum (35°C).
Press MAN, set temperature to 35°C
If the system is set up properly, the "heating" symbol should
Thu 30/12/10 appear on the thermostat display, the heating system should
begin running, and the green light on the relay box should be on.
35.
°
12:34
PM You can switch between OFF and MAN several times to verify that
0
the system is operating properly.
TARGET TEMP
4 To stop the test, press AUTO to run the program schedule, or
AUTO MAN OFF
MAN to reset the temperature manually. (If you select Manual
control, reduce the target temperature to an appropriate level.)
Make sure heating symbol appears
Thu 30/12/10
35.
°
12:34
PM 0
26
homexpert

Installer setup

Installer settings allow you to customise how your system
Thu 30/12/10
works. Check the tables on pages 28-31 to see if any settings
23.
need to be changed.
°
12:34
PM 5
Room Temp To change installer settings:
1 Press the thermostat OFF button.
AUTO MAN OFF
Press and hold to enter installer mode 2 Press and hold the i, < and > buttons until the screen
3 Press the + or - button to scroll through functions quickly
4 Press the p or q buttons to change any setting, then
12
1:CL
CLOCK SELECT
1 2
Press to scroll Press to change
through functions setting
See tables on pages 28-30 for
complete list of functions and settings
by Honeywell THR872CUK Wireless Programmable Thermostat
tm
changes.
until you find one you want to change.
press OK to save the new setting.
To exit installer setup, press any MODE button (Auto,
Manual or Off).
27