homexpert THR810LUK User Manual

User Manual

THR810LUK
Cylinder Thermostat
Installation
50051988-001 Rev. A
1 Make sure electrical power is off.
2 Use a screwdriver to remove the cover
from the thermostat as shown at left.
NOTE: If you are not experienced in
equipment installation, we recommend
that these procedures be done by a
professional installer.
DISCONNECT ELECTRIC POWER
BEFORE INSTALLATION: Can cause
electrical shock or equipment damage.
About your new cylinder thermostat
The Honeywell THR810L is an easily installed thermostat
that controls the temperature in your hot water storage
cylinder.
Installation is quick and simple. Just connect wiring as
directed, then strap the thermostat to the hot water tank
with the supplied elastic cord. There is no need to drain
the water tank.
Features:
• Reliable bimetal Micro Switch technology assures
tm
that your hot water temperature is maintained at a
comfortable level.
• Clearly marked dial is scaled to ensure accurate
temperature control.
• Secure design helps to prevent accidental changes
to temperature setting.
Wiring
Terminal
screws
Cable
clamp
1.0 - 2.5 mm²
8 mm max.
Connect wiring system to the thermostat as
shown at left. See wiring diagram on next page
for details.
1 Make sure electrical power is off.
2 Strip insulation to expose about 8 mm of
bare wire.
3 Use a screwdriver to loosen terminal screw,
insert wire into slot, then tighten screw.
4 Connect cable clamp to provide cable
strain relief.
NOTE: All wiring must comply with IEE
regulations.