Husqvarna CTH19530 Operator's Manual page 8

TO ASSEMBLY BAGGER (See Figs 6 - 8)
• Unfold bag and stand right side up.
• Feed front bagger frame (1) up through fabric loops at
each side of bagger.
• Snap bottom of front bagger frame (1) into snap feature
at front of bagger bottom.
• Slide bagger fabric loop (2) segments at the ends of
bag onto top bagger frame tubing.
• Uninstall two (1\4"-20 x 1.15") hex bolts (3) from the
front of top frame.
• Reinstall the two (1\4"-20 x 1.15") hex bolts (3) through
holes at top of the front bagger frame and thread into
nuts inside the tubing of top bagger frame.
1
• Uninstall (1/4"-20) lock nuts (4) at bottom of front bagger
frame.
• Unfold cross braces (5) and attach to carriage bolts at
bottom corners of front bagger frame.
• Reinstall (1/4"-20) lock nuts (4) and tighten until fully
seated.
NOTE: Verify rear plastic bag shield (6) is snapped in place.
6
• Remove clevis pin (7) and retainer spring (8) from bag-
ger handle (9).
• Slide bagger handle (9) down through bagger cover and
frame upper weldment holes.
• Reinstall clevis pin (7) through hole at bottom of bagger
handle and slide retainer spring (8) into hole at the end
of the clevis pin until it locks into place.
ASSEMBLY
3
Fig. 6
5
4
Fig. 7
8
TO ADJUST HANGER BRACKETS
(See Figs. 9 and 10)
The tractor comes from the factory with the bagger pivot
bracket preset in a fixed position. If necessary, this position
can be adjusted to maintain a consistent gap (A) between
the fender and the bagger assembly top. An ideal gap is
approximately 0.2" (5.1mm).
NOTE: As desired, the hanger bracket on either side can
2
be adjusted in this manner.
• Remove bagger assembly.
NOTE: ADJUST ONLY ONE SIDE AT A TIME.
VERTICAL ADJUSTMENT
• Loosen nuts on carriage bolts (1) to allow the adjust-
ment plate (2) to slide up or down. Move as needed.
Retighten nuts securely, locking the adjustment plate
in its new position.
• Repeat on opposite side.
HORIZONTAL ADJUSTMENT
• Loosen nuts on carriage bolts (3) to allow the adjustment
plate (4) to slide forward or rearwards. Move as needed.
Retighten nuts securely, locking the adjustment plate in
its new position.
• Repeat on opposite side.
A
• Readjust if necessary.
8
Fig. 8
1
Fig. 9
Fig. 10
9
7
2
4
3