TO INSTALL HOOD SCOOP (See Fig. 5)
ASSEMBLY
Fig. 5
TO ASSEMBLE BAGGER (See Figs 6 - 8)
•
Unfold bag and stand right side up.
•
Feed front bagger frame (1) up through fabric loops at
each side of bagger.
•
Snap bottom of front bagger frame (1) into snap feature
at front of bagger bottom.
•
Slide bagger fabric loop (2) segments at the ends of
bag onto top bagger frame tubing.
•
Uninstall two (1\4"-20 x 1.15") hex bolts (3) from the
front of top frame.
•
Reinstall the two (1\4"-20 x 1.15") hex bolts (3) through
holes at top of the front bagger frame and thread into
nuts inside the tubing of top bagger frame.
•
Uninstall (1/4"-20) lock nuts (4) at bottom of front bag-
ger frame.
•
Unfold cross braces (5) and attach to carriage bolts at
bottom corners of front bagger frame.
•
Reinstall (1/4"-20) lock nuts (4) and tighten until fully
seated.
•
Remove clevis pin (6) and retainer spring (7) from
bagger handle (8).
•
Slide bagger handle (8) down through bagger cover
and frame upper weldment holes.
•
Reinstall clevis pin (6) through hole at bottom of bagger
handle and slide retainer spring (7) into hole at the end
of the clevis pin until it locks into place.
8
2
Fig. 6
4
5
Fig. 7
3
1