Advertisement
Components
Remote control
The remote requires a
line-of-sight
path
allow for the signal to
be received by the
unit.
The symbols on the
Remote correspond to
the symbols on the
main unit.
Remote control battery The remote requires two "AAA" batteries. To install, remove the
battery cover on the back of the remote control and place the batteries in the "+" and "-"
direction indicated in the remote. Then reposition the cover onto the bottom of the remote. If
your remote no longer works, please try replacing with new "AAA" batteries.
Assembling your Fan
Assembly
For ease of assembly, lay the Fan down so
that the front grill and control panel
are facing up.
Assemble the Base by
interlocking the guides on Support Base A
with Support Base B. Thread the Power
Supply Cord through the large hole in the
centre of the Support Base Assembly.
(Figure1)
Secure screws into the four holes in the bottom
of the base. (Figure 2)
to
Align the Support Base Assembly with the
Column Support Assembly, NOTE :
The cord channel on the bottom of the
support base should be towards the back of
the Fan. Assemble the Support Base
Assembly to the Column Support Assembly
with 4 Screws. Gently pull any excess slack
of the Power Supply Cord and place it in the
Wire Locating Trough. (Figure 3)
Advertisement
