Replacing The Battery - Fujitsu Stylistic Q552 User Manual

Tablet pc
Hide thumbs Also See for Stylistic Q552:
Table of Contents

Advertisement

Available languages

Available languages

Low Battery State
When the battery is running low, a low battery notification message will appear. If you do not respond to the low
message, the batteries will continue to discharge until they are too low to operate. When this happens, your Tablet
PC will go into Sleep mode. There is no guarantee that your data will be saved once the Tablet PC reaches this point.
O
NCE THE LOW BATTERY NOTIFICATION MESSAGE APPEARS
UNTIL YOU CAN PROVIDE A NEW POWER SOURCE
AS SOON AS POSSIBLE
W
HEN YOU ARE IN
STYLISTIC T
Dead Battery Suspend mode shows on the Status indicator just like the normal Sleep mode. Once your Tablet PC goes
into Dead Battery Suspend mode you will be unable to resume operation until you provide a source of power either
from an adapter, or a charged battery. Once you have provided power, you will need to press the
Power/Suspend/Resume switch to resume operation.
In the Dead Battery Suspend mode, your data can be maintained for some time, but if a power source is not provided
promptly, the Power indicator will stop flashing and go out, meaning that you have lost the data that was not stored.
Once you provide power, you can continue to use your Tablet PC while an adapter is charging the battery.
Shorted Batteries
The Status Indicator panel indicator associated with the Battery Level indicator displays the operating level available
in that battery. If this display shows a flashing red LED, it means the battery is damaged and must be replaced so it
does not damage other parts of your STYLISTIC Tablet PC.

Replacing the Battery

With the purchase of an additional battery, you can have a fully charged spare to swap with one that is not charged.
There are two ways to swap batteries, cold-swapping and hot-swapping:
Cold-swapping Batteries
To cold-swap batteries in your battery bay, follow these easy steps:
. Y
.
S
LEEP MODE THERE MUST ALWAYS BE AT LEAST ONE POWER SOURCE ACTIVE
PC
S
,
ABLET
IS IN
LEEP MODE
ANY DATA THAT HAS NOT BEEN SAVED TO THE HARD DRIVE WILL BE LOST
,
YOU NEED TO SAVE ALL YOUR ACTIVE DATA AND PUT YOUR
OU SHOULD PROVIDE A CHARGED BATTERY
47 - Lithium Polymer Battery
T
PC
ABLET
,
AC
,
A
AN
POWER ADAPTER
OR
UTO
. I
F YOU REMOVE ALL POWER SOURCES WHILE YOUR
.
S
INTO
LEEP MODE
/A
IRLINE ADAPTER

Advertisement

Chapters

Table of Contents
loading

Table of Contents