Ryobi RY34426 Engine Starting

WARNING: This Engine Starting Procedure is not a substitute for
reading the operator's manual. To reduce the risk of injury, user must
read and understand operator's manual before using this product.
Cold Engine:
First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole using the funnel provided.
1
Later uses: Check engine lubricant level and add lubricant if needed.
LUBRICANT
Carefully pour fuel into the tank. Avoid spillage. Immediately replace
2
fuel cap and hand tighten. Wipe up any fuel spillage.
1 GALLON
GAS
3 PRIME
press the PRIMER BULB 10 times slowly.
10x
SET
4
CHOKE lever to " FULL CHOKE " position.
Do not squeeze throttle trigger.
With throttle at idle,
5
sharply until engine runs. (Max 3 times)
 If 60°F or lower, continue to pull starter grip until
engine runs.
HALF
 If above 60°F, set choke lever to "HALF CHOKE" and
CHOKE
pull starter grip until engine runs.
6
After 10 seconds,
RUN
Warm Engine:
Press the PRIMER BULB 10 times slowly.
RUN
Set choke lever to RUN.
10x Pull starter grip until the engine runs.
To Stop:
DEPRESS the "STOP" switch to the STOP position
PULL
starter grip
SET
choke lever to RUN position.
ENGINE STARTING PROCEDURE
NOTICE
Do not use E15 or E85 fuel (or fuel
containing greater than 10% ethanol) in
this product. It is a violation of federal
law and will damage the unit and void
your warranty.
1
Go to www.ryobitools.com and register your new tool on-line.
For any questions about operating or maintaining your product, call the Ryobi
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator's manual.
For additional registration instruction, refer to operator's manual.
7 8
5
6
2
3
RUN
HALF
CHOKE
FULL
4
CHOKE
Help Line!
®
990000202
5-28-13 (REV:04)