Transporting The Washer - Bosch WAP24200UC Use And Care Manual

When unplugging or plugging in the washer power
▯
cord, grasp the plug. Do not pull on the power cord to
unplug the washer.
The household electrical supply must be suitable for
▯
the voltage specification shown on the washer rating
plate (located inside the washer door, immediately
below the drum opening).
~ Purchase information; Page 4
See the table below for connection specfications and
fuse/breaker requirements.
Volts Hertz
208 - 240 60
The wiring for the electrical outlet circuit must be
▯
sufficient to meet the appliance requirements. Use of a
Ground Fault Circuit Interrupter (GFCI) is
recommended.
Protect the power cord from physical damage, such as
▯
being twisted, kinked, pinched, caught in a door, or
walked upon.
If the power cord is damaged, it must be replaced by a
▯
qualified person to avoid a fire/shock hazard.
Replacement power cords are available through
Customer Service.
~ Customer service; Page 4
The washing machine must only be connected to an
▯
individual branch circuit via a socket which has been
properly installed and grounded.
Make sure that:
▯
- the power plug fits into the socket
- the wire size is sufficient
- the grounding system is properly installed:
The power cord may be replaced by an electrican
▯
only. Replacement power cords are available from
Customer Service. To reduce the risk of fire or
electrical shock, DO NOT use an extension cord or an
adapter to connect the washing machine to the power
supply. If a ground fault circuit breaker is to be used,
only use the types marked with the following symbol:
. Only this symbol can guarantee compliance with
z
all current regulations.

Transporting the washer

Before transporting the washer
Disconnect the washer power cord from the wall
1.
outlet.
Turn off the water supply to the washer.
2.
Disconnect water supply lines from the tap.
3.
Disconnect the drain hose from the drain location.
4.
Install the transport bolt assemblies as shown below.
5.
Ampers Watts
12 2.880 max.
Remove the transport bolt hole covers
Remove all four transport bolt hole covers.
1.
Pull the tip of the arrow on the cover out slightly to
2.
disengage the locking tab.
Rotate the cover counterclockwise to remove. Repeat
3.
for all 4 transport bolt hole covers.
Insert the transport bolt assemblies
Each assembly consists of a plastic bushing and a
1.
bolt that extends through the bushings. Unscrew the
bolt until the threaded end is flush with the end of the
plastic bushing.
Insert the transportation bolt and bushing assembly as
2.
shown. The metal housing slides around the bolt
through the slot in the plastic bushing as the bushing
is slid into place. The open part of the bushing slot
should be facing the direction shown to allow the
assembly to slide fully into place.
When the bolt is in place screw it in until the bolt
3.
threads engage the drum. Double check and ensure
bolts are screwed into threaded holes and not into
adjecent cracks or crevices. Repeat the process for all
4 transportation bolt assemblies before tightening any
all the way. Complete tightening all 4 bolt assemblies
until they are each snug in place.
15