Transporting The Washer - Bosch WAT28400UC Use And Care Manual / Installation Instructions

Transporting the washer

Before transporting the washer
Disconnect the washer power cord from the wall
1.
outlet.
Turn off the water supply to the washer.
2.
Disconnect water supply lines from the tap.
3.
Disconnect the drain hose from the drain location.
4.
Install the transport bolt assemblies as shown in the
5.
following images.
Remove the transport bolt hole covers
Remove all four transport bolt hole covers.
1.
Pull the tip of the arrow on the cover out slightly to
2.
disengage the locking tab.
Rotate the cover counterclockwise to remove. Repeat
3.
for all 4 transport bolt hole covers.
Insert the transport bolt assemblies
Each assembly consists of a plastic bushing and a
1.
bolt that extends through the bushings. Unscrew the
bolt until the threaded end is flush with the end of the
plastic bushing.
Insert the transportation bolt and bushing assembly as
2.
shown. The metal housing slides around the bolt
through the slot in the plastic bushing as the bushing
is slid into place. The open part of the bushing slot
should be facing the direction shown to allow the
assembly to slide fully into place.
When the bolt is in place screw it in until the bolt
3.
threads engage the drum. Double check and ensure
bolts are screwed into threaded holes and not into
cracks or crevices. Repeat the process for all 4
transportation bolt assemblies before tightening any all
the way. Complete tightening all 4 bolt assemblies
until they are each snug in place.
17