Table of Contents
Advertisement
MENU—Press to access additional settings and configuration
options. Press to return to the previous screen when indicated.
Acquiring GPS Satellite Signals
When you turn on the unit, the GPS receiver must collect satellite
data and establish the current location. When the unit acquires
satellite signals, the signal strength bars at the top of the Home
screen are green
. When the unit loses satellite signals, the
green bars disappear
and the position icon displays a flashing
question mark.
For more information about GPS, visit the Garmin Web site at
www.garmin.com/aboutGPS.
Using Simulator Mode
Simulator mode turns the GPS receiver off for use indoors or for
practice. The unit does not track satellites in simulator mode.
Do not try to navigate using simulator mode, because the GPS
receiver is turned off. Any satellite signal-strength bars shown are
only simulations and do not represent the strength of actual satellite
signals.
GPSMAP 400/500 Series Owner's Manual
WARNING
To turn on Simulator mode:
1. From the Home screen, select
Simulator.
2. Select
Setup
to set speed, track control, and position.
Viewing System Information
You can view the software version, the basemap version,
supplemental map information (if applicable), and the unit ID
number for your chartplotter. You may need this information to
update the system software or to purchase additional map data.
From the home screen, select
Information.
Restoring the Original Factory Settings
NOTE: This procedure deletes all settings information you have
entered.
1. From the Home screen, select
Information
>
Factory
Settings.
2. Select
Yes
to restore all factory settings, or select
The unit reboots and prompts you to adjust unit settings
Getting Started
Configure
>
System
>
Configure
>
System
>
System
Configure
>
System
>
System
No
to cancel.
(page
2).
5
Hide quick links:
Advertisement
Table of Contents
