Initial Installation; Setting The Remote Control To Operate The Tv; Connection; Switching On - Loewe ? Nemos 32 ? Nemos 29 ? Nemos 28 ? Mimo 29 ? Mimo 28 ? Aventos 3981 ZW ? Aventos 3972 ZP ? Aventos 3970 ZW ? Aventos 378 Operating Instructions Manual

Initial installation

Remote control
Batteries
To insert or change the batteries, press the point
marked by an embossed arrow. Push the cover of
the battery compartment down and remove it. In-
sert the batteries of the alkaline manganese type
LR 03 (AAA) with the correct polarity (+/–).
Then push the cover back on.
Note on disposal of batteries:
The original batteries do not
contain any pollutants such as
cadmium, lead and mercury.
Used batteries do not belong in
the domestic waste. They must
be taken to the appropriate col-
lection points according to the
national laws.
Setting the remote control to operate the
TV set
Press the TV button
TV
How to operate other Loewe equipment is de-
scribed on page 20.

Buch32399_Auflage3_D_I_GB 9

Connection

Mains
Connect the TV set to a 230V/50–60 Hertz outlet.
Antennas
At Mimo TV set: Remove the rear cover from the
set by pulling backwards. Clamp the cable in the
cable holder and lead it downwards through the
opening.
+
Plug the antenna plug which comes out above
the PIP antenna socket into the antenna socket of
the VHF/UHF tuner. Plug the antenna plug of your
antenna or cable system into the PIP tuner socket.
If equipped with a DVB-T module 2 T -CI connect
+
your antenna system to the upper socket of the
DVB-T module (IN) and connect the lower socket
(OUT) to the antenna input of the PIP tuner.
If equipped with the terrestrial digital tuner 2
T-Basic a common antenna is used for digital and
analog signals, connect the terrestrial digital tuner
and the analog tuner to the antenna system via an
antenna splitter.
If equipped with one or two satellite tuners, con-
nect the Sat antennae to the SAT sockets (see fi g.
page 5).
Refi t the cover to the Mimo TV set.
SAT
SAT A/D
VHF/UHF
SERVICE
AV1 AV2/RGB
R
AUDIO OUT
L
SUBWOOFER
STAND

Switching on

For Nemos: the display and on/off switch are ac-
commodated in a single unit.
Press the On/Off
button so that it
snaps in.
Initial installation
Automatic programming of the TV set is started the
fi rst time you switch it on. Follow the menus.
First you have to select the menu language for
your set. Then you specify which antenna you have
connected to your TV and in what country you are
using it. Then you start the station search. The TV
set searches for, stores and sorts all the stations
which your antenna system receives. You then see
a list of the stored stations in which you can mark
your favorites. Finally log in your video recorders,
decoders, Loewe audio system and Home Automa-
tion with the connection wizard and connect these
to the TV set according to the illustrated connection
plan.
Pressing the OK button in the
direction of the arrow to select the
OK
settings
... confi rm the settings with OK.
OK
You then move on to the next
menu ...
... press this button if you want
information about the settings.
You can repeat initial installation at any time, e.g.
after moving house. Call the index in the main
information (info button). Then select the item
"Repeat initial installation". Then start "Initial
installation" with OK.
12.05.2005, 11:20:05 Uhr
9